This Forum is supported by C&C 27 owners like you whose membership in the C&C 27 Association makes possible this Forum and the accompanying site. Thank you, members, for your continuing commitment.
You are not logged in.
I am trying to find a suitable replacement for the Marmac Engine Controls. Has anyone replaced these controls and if so, what did they use? Engine is a Yanmar 1GM10. Thanks
Keith Skiffington
Keiro
C&C 27 Mark V
Keith Skiffington
Keiro
C&C 27 Mark V
Offline
Looks like someone has had success with replacing with a Morse MV-2 (later version is the MV-3).
http://www.westsail.org/discus/messages/11/1300.html?1204908565
My transmission cable end snapped, due to the engine control handles spinning too far around. I need a better solution and the morse may be the answer http://www.correctcraftfan.com/Downloads/Morse_MV-2_Owner_Manual.pdf
No more holding one lever while moving the other?! I wonder if the cable will fit. I hope not to have to replace both cables and the control.
Any experience out there?
Tim Quinton
Dark'n'Stormy
Sail 610
C&C Mk V
Offline