This Forum is supported by C&C 27 owners like you whose membership in the C&C 27 Association makes possible this Forum and the accompanying site. Thank you, members, for your continuing commitment.
You are not logged in.
Pages: 1
What if any is the structural requirement of the two aluminum pieces on either side of the mast? I can't see anything other than the two pins that go through them to hold the mast while stepping fore and aft. Why couldn't you drill about 4 3/8" holes in each of them where they pass by the front and rear end of the mast to attach blocks to go to deck organizers for halyard and control lines? Say two in front and two in back.
Thanks,
Martin
C&C 27 Mark III 1978
"Shifts and Giggles"
Hull#670
[Descriptive thread titles not only help people to answer your question (which may not be as stupid as your original title suggested you believe it to be), they help people find the answers they're looking for at a later date. - Admin]
Last edited by (2010-02-13 02:11:50)
C&C 27 Mark III 1978
Hull#670
"Shifts and Giggles"
Offline
Pages: 1