This Forum is supported by C&C 27 owners like you whose membership in the C&C 27 Association makes possible this Forum and the accompanying site. Thank you, members, for your continuing commitment.
You are not logged in.
Folding Cradle
I would greatly appreciate any leads to purchase one or to get the dimensions of someones to have one built. My original shipping cradle was tossed at the place of purchase before I could get some measurements <img src="emoticons/icon_sad.gif"> I have read that the keel can't support the weight of the boat so I really want to get this right.
Thanks in advance
Keith
I believe its David whom is responsible for this great site full of info.
Thanks and I'll be sending a check (well worth it)
[Thank you for your kind remarks. Praise is always welcome (but cash keeps the electrons humming down the wire). Also, bear in mind that much of the info on the site is not single-source but the collected wisdom (and accumulated mistakes) of the Association. BTW, if you want a cradle "off-the-rack", try the Marine Cradle Shop, under
http://www.cradleridetrailers.com/ - Admin]
Last edited by (2006-09-08 07:02:22)
Have a look under the, "Fleet" - Morgan "D". If that's what you want I'll send you those. A racer at my club made that from scratch - fits/works perfectly.
Dean M Baldwin
Morgan "D"
Mark III - Hull 516
Halifax, N.S.
Dean M Baldwin
Morgan "D"
Mark III - Hull 516
North Sydney, N.S.
Offline
Thanks Dean
I seen the picture of your cradle and had printed it out before
your reply. It looks like an exact match to the original wooden one.
I love to receive some more information if possible.
You can contact me at the address below.
takeachancecnc@yahoo.ca
Thanks again
Keith
Lasalle, Ontario
Mark I - Hull 151